Crush for manual hoof care

Watch movie >>

The GDS  manual hoof care crush is a sturdy, hot-dip galvanised crush. It comes ready for use so that you can trim the hooves of your own cattle.

Cow is being locked in by closing yoke via a pulley at the side of the crush .To exit the crush , yoke is unlocked and door opened.

The front door is also a safety door from which the cow can always be released by opening the two bars.

Electric rear leg hoist as standard to ease the lifting of the hind legs. Wide rubber belly band , operated by a safety ratchet, provides secure support to lift all 4 feet.

  

The front legs are manually lifted onto the frontleg blocks by means of hand wind ratchets.  Frontleg supports can be adjusted in height  On the right-hand-side of the crush there’s an integrated electrical socket for three plugs, which, for example, is useful when using a grinder  This grinder can be hung in the holder supplied on the nodd gates  Getting the cow into the crush is made easier with the use of the nodd gates at the back of the box  .Floor has large rear stabilisers to prevent that the crush will be overturned by the cow.

Optional

• Spring assisted rump bar to better secure hind feet .

 

• Rubbermat.

• Transport axle

Measurements:

Length: 200 cm
Width bottom plate: 114 cm
Inner measurements:      72 cm
Height exterior: 200 cm
Height interior: 168 cm
Foreleg support:  135 cm